8. Slide Fiberglass Rods #17 together and insert into Sleeve #18. Next insert one end of the fiberglass rod #17 and sleeve
#18 into the triangular pocket on the FRONT upper outside corners of the net. The rod will then remain on the front of
the net until it reaches the
second
diagonal square from the lower inside corner as shown in
Detail 6
. Push it though this
hole and down into the fiberglass rod pivot connector. Then carefully take the fiberglass tube sleeve and slide it over the
pivot connector as well. Do this for both sides. Make sure to slide part #17 (Rod Sleeve) over pivot connector as well. At
this point the Yard Guard should be free standing.
Detail 6
Second
diagonal
square
Detail 7
Detail 6
17
17
18
*Rim
& Ne
t not
show
n
for cla
rity.
For systems with a hoop light only.
6. Using a ladder take the upper pole bracket #16 with Protective
surface facing the pole, slide the shorter U-bolt #15 through
bracket to attach the Nets as shown in
. Attach nuts so
Detail 4
that the bracket may still move up and down. Carefully position
assembly so that net is fairly tight and most of the slack is
removed. At this point tighten nuts snug so that the U-bolt and
bracket cannot move. DO NOT CRUSH the grommet in the net.
7. If using a hoop light remove the LOWER nuts as shown in
and attach net to lower U bolt on Light Bracket as
Detail 5
instructed on Step 6.
Detail 4
Detail 5
For systems with a hoop light only.
Figure 3
4
5
14
16
15
13
4L-8156-00
WARNING
!
13
14
Warn
ing la
bel
Logo
Protective Surface
6
SKIP TO PAGE 11
TO CONTINUE THE INSTALLATION
