I S A
GO Systemelektronik GmbH Faluner Weg 1 24109 Kiel Germany Tel.: +49 431 58080-0
Fax: -58080-11
Page 13 / 76
www.go-sys.de
5 Notes for Operation
5.1 Safety Instructions and Warnings
Please read carefully the operating manuals before starting BlueBox and ISA. Keep these manuals at hand. Do
not pass the BlueBox or the ISA on to other persons without their user manuals. The manufacturer does not
take responsibility for incorrect handling or operation.
The instrument is constructed according to the low voltage code and to the safety regulations for electronic
measuring devices.
Correct function and safety can only be ensured when both general and system-specific safety measures are
followed.
Before connecting the power supply, make sure that the power supply voltage is suitable.
Correct and safe function can only be maintained under the climatic conditions specified in chapter 2 "Tech-
nical data”.
If the instrument is moved from a cold to a warm environment, condensation might form which could influ-
ence its function. In this case, wait for the instrument to reach equilibrium with the new surroundings before
use.
Maintenance and repairs may only be carried out by GO-authorised technicians.
If it is suspected that the instrument cannot be used without danger, it must be shut down and prevented
from further use.
The user’s safety might be affected if the instrument shows signs of damage, does not function properly, has
undergone long storage under unsuitable conditions or was subject to extreme transport conditions.
If in doubt, contact the manufacturer "GO Systemelektronik GmbH” and send the instrument for repair or
maintenance if necessary.
Caution:
The sensor head must not be exposed to negative pressure or pressure shocks.
Caution:
The fibre optic cable must not be bent or flexed with a radius less than 40 mm.
Caution:
The sensor head must not be hung on the sensor head cable, please use the lugs
for installation of the Sensor head.
