I S A m o b i l e
GO Systemelektronik GmbH Faluner Weg 1 24109 Kiel Germany Tel.: +49 431 58080-0
Fax: -58080-11
Page 69 / 76
www.go-sys.de
3 Commissioning
1.
Open the case.
2.
Mount the fuse (if needed).
3.
Charge the accumulator batteries with the supplied charge device (via the 12 V DC connection at the
outside right of the box). The charging time is 8 hours in total discharge.
The supplied charge device has a three-colour indicator light:
red
– The charge device is not connected.
orange – The charge device charges.
green – The charging process is completed.
4.
Pull the tab on the holding clamps to the top.
5.
Disconnect the sensor head from the holding clamps and insert the sensor head with the sensor head
cable through the screw hole in the foam sleeve to the outside. The sensor head cable may not be in a
tighter radius than 40 mm bent or kinked. It also requires the sensor head will not be suspended from
the measuring head cable, use instead the lugs at the sensor head.
6.
Close the inside of the screw hole with the union nut of the sensor head cable.
