I S A
GO Systemelektronik GmbH Faluner Weg 1 24109 Kiel Germany Tel.: +49 431 58080-0
Fax: -58080-11
Page 9 / 76
www.go-sys.de
3 Scope of Delivery
The spectral analyser is available in three versions:
•
ISA TS
BlueBox TS with integrated spectrometer sensor unit
∗
•
ISA T4
BlueBox T4 with one or more external spectrometer sensor modules
•
ISA mobile
ISA TS with two accumulator batteries and a power up control module
(Power Management Module PMM) integrated in a suitcase
3.1 Scope of Delivery ISA TS, ISA T4
1.
BlueBox
If the spectrometer will not be integrated into an existing BlueBox system, the BlueBox is part of the deliv-
ery. The BlueBox is the central control unit of the ISA. In the BlueBox measured data are saved and for-
warded, the values for the desired parameters are calculated and calibration parameters are stored. Via
the PC interface all ISA data and settings can be remotely controlled and read out for further processing.
The BlueBox is delivered with all the required accessories. Information about the properties, installation
and use of the BlueBox can be found in its attached manual.
2.
Sensor
-
head
The ISA sensor head is manufactured from high grade steel (optional titanium). Only the optics and the
compressed air cleaning are integrated in the measuring head. The sensor head can thereby be deployed
in high temperature ranges (up to +110 °C).
3.
Sensor
-
head
-
cable
The sensor head is connected with the spectrometer sensor module via the special covered sensor head
cable. The spectrometer sensor module contains all the electronics. In the measuring head cable there are
two fibre optic cables and a compressed air line. The probe cable must not be bent or kinked in a tighter
radius than 40 mm. At installation the sensor head shall not be hung up at the measuring head cable;
therefore use the appropriate lugs.
4.
External spectrometer sensor module with compressed air connector
The entire ISA control- and analysis-electronics are fitted in the CAN-bus sensor module.
5.
Software
USB stick with the system software and the manuals
6.
USB Dongle
Protection against unauthorized access
7.
Configuration data sheet BlueBox TS/Spectrometer unit of sensor module
8.
Spectrometer data sheet
from Zeiss
9.
CAN-bus cable
(only ISA T4)
∗
Additional sensor units can be connected with external sensor modules via the CAN bus interface.
