USAGE OF CONTROL PANEL
10 - STAND-BY
Is for stand-By the machine.
☞ STAND-BY MODE ?
When you leaves the machine for long time, the roller temp. can be controlled below 80℃
or cut off the power of machine.
1) Setting by Users
: For short time, if you does not operate the machine, it can be used.
At the normal condition if you press the "STAND-BY" button, the setting temp.
can be changed to 80℃ automatically. (The operating condition stops)
2) Automatic setting by microprocessor :
If you leave the machine for 3hours,
micro-processor installed in machine controls the roller temp. below 80℃.
(If the setting temp is below 80℃, it is controlled at the 0℃)
At this time, stand-by display lamp is on, Job display or Heater display window is cleared.
and then one and half hour passed, Stand-by Mode flickers and Power of heater is cut off.
Note
: At the above two condition, release of standby mode is available by pressing
"STAND-BY" button again. If the saving mode is released, all conditions come back
to the previous status of stand-by mode.
EXCELAM-1670SWING
Before Stand by Mode
STAND-BY MODE
Setting(Safety) Mode
Release STAND-BY
10
19/39
