GLP KNV Dot, Quick Start And Safety Manual

Page: 45 / 65

German Light Products®
KNV Dot and Line Quick Start and Safety Manual Rev. A 45
If there is a risk of injury or damage if the PSU falls, secure it with an approved safety
cable passed through one of the holes
E in the mounting plate (or through one of
the PSU’s handles) and then looped around a secure anchoring point. Take up as
much slack as possible in the safety cable before you fasten it.
3. Mounting on a truss using two rigging clamps and M12 bolts
To mount a KNV PSU on a rigging truss using two rigging clamps and M12 bolts:
Obtain two half-coupler type rigging clamps and high-tensile M12 bolts or screws.
The clamps and bolts must be approved for the total weight that they will support.
See Figure 29. Fasten the rigging clamps to the PSU’s mounting plate by passing the
M12 bolts through the clamps and through the 13 mm holes
E in the mounting
plate. Install washers and self-locking nuts on the end of the bolts and tighten the
bolts. The bolts must not touch the PSU’s housing. Use shorter bolts if necessary.
Lift the complete assembly up to the rigging truss and fasten the rigging clamp to
the truss.
If there is a risk of injury or damage if the PSU falls, secure it with an approved safety
cable passed through one of the PSU’s handles and then looped around a secure
anchoring point. Take up as much slack as possible in the safety cable before you
fasten it.
4. Mounting on a truss using one rigging clamp
To mount a KNV PSU on a rigging truss using a single rigging clamp and M10 bolt:
Obtain a half-coupler type rigging clamp and a high-tensile M10 bolt or screw. The
clamp and the screw or bolt must be approved for the total weight that they will
support.
Figure 29. KNV PSU 13 mm threaded holes
E E