GLP KNV Dot, Quick Start And Safety Manual

Page: 36 / 65

www.glp.de
36 KNV Dot and Line Quick Start and Safety Manual Rev. A
Standing a KNV Line on a level surface
You can place the KNV Line standing horizontally on a stable, flat horizontal surface.
You can also place it standing
vertically on the surface if you take precautions to
make sure that the KNV Line cannot fall and become damaged.
If you want to aim the KNV Line at any other angle than horizontal or vertically
upwards, fasten the KNV Line into the adjustable KNV Floorstand / Hanging Bracket
accessory before placing on the surface (see instructions below).
Whether you place KNV Line fixture directly on the surface or use an adjustable
Floorstand / Hanging Bracket, make sure that the fixture and cables will not present a
danger. Make sure that persons cannot accidentally touch or trip over the fixture when
it is installed. If there is a danger of injury or damage if the fixture falls, secure the fixture
with a safety cable as described in ‘Securing with a safety cable’ on page 19.
Standing using a Floorstand / Hanging Bracket
To use the Floorstand / Hanging Bracket to stand a KNV Line on a surface:
Place the Floorstand / Hanging Bracket on a stable horizontal surface and move its
legs to the fully open position at about 90° apart as shown in Figure 21.
See Figure 19 on page 35. Move the mechanical connector locking knobs on both
sides of the Floorstand to the Unlocked position.
Slide the mechanical connector profiles on the Floorstand into the channels on
both ends of the KNV Line.
See Figure 19. Push the locking
knobs on both sides of the
Floorstand towards the fixture into
the Locked position. The locks snap
into place under spring pressure.
Check that the fixture is held
securely in the Floorstand.
If necessary, loosen the
handscrews (arrowed in Figure 21)
on both sides of the Floorstand and
adjust the fixture’s tilt angle, then
retighten the handscrews.
Figure 21. KNV Line Floorstand / Hanging
Bracket