GLP KNV Dot, Quick Start And Safety Manual

Page: 37 / 65

German Light Products®
KNV Dot and Line Quick Start and Safety Manual Rev. A 37
Flying a single KNV Line from a rigging truss
Suspending from a KNV Line Bracket
The KNV Line Bracket fastens into channels on the top and bottom of KNV Lines. It lets
you fasten a rigging clamp to a KNV Line and fly the fixture from a rigging truss.
To fly a KNV Line from a rigging truss using a KNV Line Bracket:
See Figure 22. Bolt a half-coupler type rigging clamp A to the KNV Line Bracket B
using a suitable hardened steel bolt and a new self-locking nut.
See Figure 19 on page 35. Push the locking knobs on both of the Bracket’s
connector profiles
C to the Unlocked position.
Push the connector profiles C fully into the mechanical connection channels D on
the KNV Line.
Push the locking knobs on both sides of the Bracket towards the fixture into the
Locked position (see Figure 19 on page 35). The locks snap into place under spring
pressure. Check that the Bracket is securely locked to the fixture on both sides.
Lift the rigging clamp, bracket and fixture up to the rigging truss and fasten the
clamp around the truss.
If there is a danger of injury or damage if the fixture falls, secure it with a safety
cable that is approved for the total load that it will secure as described in ‘Securing
with a safety cable’ on page 19.
C
C
D
D
A
B
Figure 22. Connection channels and KNV Line Bracket