REV. 01 2020
CHAPTER 4 – COMMISSIONING
4.1 SPACE REQUIRED
When choosing
safety at work regulations
Do not operate the balancer while it is on the pallet.
•
The balancer must be located on a flat floor of solid construction, preferably concrete. The
balancer must sit solidly on its
function properly and may produce inaccurate balance readings.
•
Select a location for the balancer that provides a level, solid floor, and adequate clearance
around and above the balancer.
shown in pictures Fig. 3 and Fig. 4
and without any restriction.
•
Make sure the location selected has enough room above an
guard can be raised completely.
and removing wheels. Make sure the area has adequate lighting.
•
If the machine is installed
4.2
SHAFT ASSEMBLY
•
Mount the thread end piece
screwing the retaining screw (B).
•
Tighten the retaining screw (B)
using the supplied wrench
Fig. 3
8 / 28
COMMISSIONING
the place of installation, make sure that it
regulations
.
o not operate the balancer while it is on the pallet.
The balancer must be located on a flat floor of solid construction, preferably concrete. The
balancer must sit solidly on its three feet. If the balancer is not leveled, the balancer will not
and may produce inaccurate balance readings.
elect a location for the balancer that provides a level, solid floor, and adequate clearance
around and above the balancer.
The place of installation must also provide
Fig. 3 and Fig. 4 so as to allow all parts of the mach
restriction.
Make sure the location selected has enough room above and behind the machine so the
can be raised completely. The location must also provide working room for mounting
Make sure the area has adequate lighting.
installed outside it must be protected by a lean-to.
the thread end piece (A) onto the shaft by
screwing the retaining screw (B).
Tighten the retaining screw (B) thoroughly by
ing the supplied wrench (C).
Fig. 5
Fig. 4
it complies with current
The balancer must be located on a flat floor of solid construction, preferably concrete. The
feet. If the balancer is not leveled, the balancer will not
elect a location for the balancer that provides a level, solid floor, and adequate clearance
provide at least the space
machine to operate correctly
d behind the machine so the wheel
he location must also provide working room for mounting
A
B
C
