Page 8
THIS MACHINE IS PROVIDED WITH A THREE-PRONG GROUNDING PLUG. THE OUTLET TO
WHICH THIS PLUG IS CONNECTED MUST BE PROPERLY GROUNDED. IF THE RECEPTACLE IS
NOT THE PROPER GROUNDING TYPE, CONTACT AN ELECTRICIAN. DO NOT, UNDER ANY
CIRCUMSTANCES, CUT OR REMOVE THE THIRD GROUND PRONG FROM THE POWER CORD
OR USE ANY ADAPTER PLUG (FIG. 8-1 AND FIG. 8-2).
5. Inspect slicer to make sure all parts have been provided.
6. Make sure knife cover and knife sharpener are in place.
7. Make sure the warning label is properly positioned and legible. Instruction manual must be available near
slicer.
8. Post the provided wall chart in a visible area near the slicer to be referred to often for cleaning, sanitizing,
and inspecting slicer. Refer to the wall chart and Owner’s Manual for proper cleaning, sanitizing and
inspection of your slicer.
9. Clean slicer using the procedures outlined in the Cleaning & Sanitizing section of this manual before using
the slicer.
10. Contact your local representative if you have any questions or problems with the installation or operation of
this slicer.
Installation
Figure 8-1 Correct
Figure 8-2
INCORRECT
