Page 7
Installation
UNPACKING
Unpack slicer immediately after receipt. If the machine is found to be damaged, save the packaging material and
contact the carrier within fifteen (15) days of delivery and immediately contact your source of the equipment.
You
have no recourse for damage after fifteen (15) days of receipt.
Four rubber feet, lubricating oil, wall chart and an instruction manual are included with slicer. Contact your local
supplier if you did not receive all of these items.
TO AVOID SERIOUS PERSONAL INJURY
PROPERLY INSTALL SLICER IN ADEQUATE WORK AREA
•
ALWAYS
install equipment in a work area with adequate light and space.
•
ONLY
operate on a solid, level, nonskid surface that is nonflammable.
• NEVER
operate slicer with a damaged power cord or power plug.
• NEVER
operate slicer with an extension cord.
•
NEVER
bypass, alter, or modify this equipment from its original condition. Doing so can create hazards
and will void warranty.
• NEVER
operate slicer without the knife cover securely installed.
• NEVER
operate slicer without warning label attached (Refer to Key Components of the Slicer).
INSTALLATION:
1. Read this manual thoroughly before installation and operation. DO NOT proceed with installation and
operation if you have any questions or if you do not understand everything in the manual. Contact your local
representative. Make sure to clean and sanitize entire slicer before use. Refer to this manual for cleaning and
sanitizing guidelines.
2. Remove slicer from the corrugated box.
3.
Make sure the rubber feet are firmly tightened.
NEVER USE SLICER WITHOUT RUBBER FEET INSTALLED.
4.
Select a location for the slicer that has a level, solid, nonskid surface that is nonflammable and is in a well-lit
work area that is away from children and visitors.
USE AT LEAST TWO PEOPLE TO LIFT SLICER UP TO THE OPERATING LOCATION. NEVER
ATTEMPT TO LIFT THE SLICER ALONE.
