Globaljig Quick Pull, Instructions For Installation, Use And Maintenance Manual

Page: 22 / 37

22
13. INSPECTION AND MAINTENANCE
ATTENTION
Before performing any kind of operation upon the lift, remove the
load and disconnect the electrical power supply.
It is recommended to clean and check the machine every 10 days. Remove
any dirt with self-cleaning rags (never use water or flammable/corrosive
liquids), check the cleanliness of the wheel guides (especially the lower
ones) and make sure they are properly lubricated with grease.
Check that the 4 lifting arms move freely.
Periodically check the electrical connections (limit switches and arm sensors)
and the hydraulic system’s joints.
Notify the manufacturer’s assistance centre if any anomalies are
encountered.
Every 30 days, remove the front panel to check the control unit’s tank oil
level.
Oil type: Hydraulic – viscosity 32
14. WARRANTY
The Quick Pull is covered by warranty, in its entirety, for 24 months on the
express condition that no tampering or improper interventions have taken
place and that the machine’s identification data, shown both on the
machine’s labels as well as in this manual, have not been damaged or
removed. With regards to cases covered under warranty or of specific parts
subject to normal wear, the manufacturer reserves the right to satisfy the
customer’s request based on the entity of the damage and on the feasibility
of restoring the Quick Pull in terms of the mechanical safety and
functionality. Interventions claimed under warranty are governed by the
relative legal provisions.
15. DECOMMISSIONING AND DISPOSAL
When decommissioning and disposing of the lift or its parts, the current local
waste disposal regulations must be respected and the machine’s iron parts
must be recycled wherever possible. Each part of the machine must be
disposed of based on its typology.