2=CA&
% 5AHEAI
SECTION 3: CONFIGURATION
Single Price S Models
SETTING THE VEND PRICE/OPTION
SWITCH
Located behind the acceptor in the middle right
hand side of the changer housing are twelve
switches (see figure 2). The vend price is set
using the first eight switches, the last four
switches are used to enable or disable different
options.
VEND PRICE
The vend price is set in single increments up to
255 times the lowest denomination coin ac-
cepted by the changer and routed to a coin tube.
In most cases this will be a nickel.
Example: If the lowest denomination coin
accepted to a tube for payout is a nickel, the
highest vend price setting would be 255 (times)
.05 or $12.75, in this case the value of the price
switches are: 1=.05, 2=.10, 3=.20, 4=.40, 5=.80,
6=1.60, 7=3.20, 8=6.40.
When the top of the rocker switch is pushed in,
it is in the ON position. If switches 1, 3 and 4
are ON, the vend price would be $.65, if the
lowest denomination coin accepted to a payout
tube is a nickel.
OPTIONS
SWITCH A (SWITHC 9)
Controls the escrow feature of the changer.
ON
Escrow inhibited
OFF
Escrow enabled
SWITCH B (SWITCH 10)
Not used.
SWITCH C (SWITCH 11)
Vend signal length.
ON
Vend is held until a selection is made
OFF
Vend is pulsed (300 msec)
SWITCH D (SWITCH 12)
When to enter “Use Correct Change” condition.
ON
The changer will use the vend price plus
the largest denomination coin accepted
(U.S. = $1.00). This is the amount of
money reported in the tubes to the logic
board to shut the correct change light
off.
Example: $.50 vend price pluse $1.00
coin = $1.50
OFF
The changer uses the factory settings.
U.S. = $1.00, Canada = $2.00
SAVING THE VEND PRICE
To save the vend price and option switch
setting (in the coin changer’s memory), press
and release the Mode Button located above the
price switch. The Main Logic Board LED and
the “Use Correct Change” light on the vendor
will flash once, indicating that price was re-
corded.
The vend price must be set to an amount greater
than zero for the changer to accept coins.
Note: If a Single Price Changer is used in an
MDB machine, set the vend prices on the
machine controller board, NOT in the coin
changer.
