2=CA$
% 5AHEAI
Installing The Changer
1.
Remove power from vendor.
2.
Remove the acceptor from the changer by
pressing down and releasing the acceptor
latch, releasing the acceptor. Rotate the
top of the acceptor forward, away from the
changer (see figures 1 and 2). Unplug the
ribbon cable from changer. Free the lower
acceptor studs from changer housing.
Place the acceptor in a clean area.
3.
With the acceptor removed, set the mount-
ing holes in the back of the changer hous-
ing over the mounting screws in the ven-
dor. Tighten snugly (see Figure 3).
4.
Re-install the acceptor by inserting the
lower acceptor studs into the changer
housing guides. Plug the ribbon cable into
the changer (see Figure 2).
5.
On Single-Price units using the DEX/UCS
Hand-Held Computer, attach the DEX
plug ground connector to the vending
machine frame (see Figure 1).
6.
Plug changer into vendor socket.
7.
For Single-Price units and Canadian Four-
Price units, set the desired vend price and
options on the changer (refer to “Setting
the Vend Price” and “Option Switch
Settings).
8.
Press top of the acceptor into the changer
housing until the acceptor latch locks.
9.
Load the tubes with coins (see “Hand
Loading” and “Loading Through the
Acceptor”).
10. (Optional) Set the coin tube float levels
(refer to “Setting The Float Mode Lev-
els”).
11. Check to make sure the front cover, tube
shield and acceptor are properly installed.
12. Test the changer with a variety of coins to
ensure proper operation.
Figure 1
Figure 2
SECTION 2: INSTALLATION
