2=CA#
% 5AHEAI
REMOVING THE LOGIC BOARD COVER
To remove the logic board cover, first remove
the strain relief bracket and screw. Next,
remove the screw in the lower center portion of
the logic board cover. Lift the cover out.
REMOVING THE UPPER TUBE SENSOR
BOARD
Connected to the bottom of the main logic
board is the upper tube sensor board. To re-
move the sensor board, release the locking tab
and gently pull the sensor board out. As you
pull the sensor board out, hold the main logic
board in place and the sensor board will unplug
from the main logic board.
REMOVING THE LOGIC BOARD
Unplug the remaining harnesses from the main
logic board and lift it out of the housing.
REMOVING THE PAYOUT BASE
ASSEMBLY
With the harnesses disconnected from the main
logic board, remove the two screws (one on
each side) from the changer housing. Lay the
changer on its back and spread the sides of the
housing apart. Pull up and out on the payout
base assembly.
REMOVING THE CASHBOX CHUTE
From the backside of the changer housing,
remove the tape seal from the cashbox chute.
Lift the bottom of the chute up and slide the
cashbox chute out.
REMOVING THE CASHBOX CHUTE
From the backside of the changer housing,
remove the tape seal from the cashbox chute.
Lift the bottom of the chute up and slide the
cashbox chute out.
Clearing Coin Jams
Should a coin jam occur in the cash box chute
area, use the following steps to help dislodge
coins:
1. Remove changer from vendor.
2. Keeping changer in an upright position,
remove cash box chute (located on the back
of the changer) by pulling lower edge out
and down at the same time.
3. Remove any lodged coins.
4. Replace the cash box chute by pressing in
and up to snap into place.
SECTION 4: MAINTENANCE
