ROLL.in.One Installation Instructions & O
wner’s
Manual
Page 8
Operating Panel
1.
[C] button - coding button
2.
[S] button
Press and hold
< 0.5 second
- single button operation (when limit is already set)
Press and hold
> 0.5 second
and
<1.5 seconds
- no action
Press and hold
> 1.5 seconds
- enter functional setting
1.0 Transmitter Coding
–
By Controller
3.
Press[C] button once
4.
[CODE] will light with 3 beeps
5.
Press the desired operation key on transmitter
6.
LED will diminish to signal successful programming
1.1 Transmitter Coding
–
By Transmitter
1.
Using an already programmed transmitter, press and hold OPEN & STOP keys
simultaneously for 2 seconds
2.
Unit will beep three times to signal for Learn Mode
3.
Press the desired operation key on the new transmitter
4.
A beep will signal for successful coding. Two beeps signal for a transmitter
already in memory
5.
Unit will automatically exit the setup after 3 seconds
2.0 Transmitter Key Setting
1.
Press and hold [S], release finger while the red light turns from [F] to [K]
2.
Press [S] again, when the light of [SEL/ADJ] turns RED or GREEN:
RED
indicates 3 button operation
GREEN
indicates single button operation
[KEY1] STOP
[KEY2] OPEN
[KEY3] CLOSE
Fig: 10
Fig: 11
