ROLL.in.One Installation Instructions & O
wner’s
Manual
Page 3
Installation Instructions
The
Roll.in.One
unit may be retrofitted to any roller doors including non Gliderol doors and also it does not require
any disassembly of the door during installation.
The
Roll.in.One
unit may be retrofitted to either side of a roller door. Selection of the desired side may be
determined by the available room, location of power and general installation.
In some circumstances the wall bracket may need to be relocated if the distance between the side edge of the
bracket and face of the drum wheel is greater than 130mm or less than 70mm (110mm for Gliderol doors
drumwheel recessed at 75mm from edge of curtain).
Furthermore the face of the drum wheel should not be recessed more than 75mm from the edge of the curtain.
The door must be in good working conditions, adjustments to spring tension may be required.
These instructions are to be read in conjunction with Roller Door Installation instructions.
Please note:-
THE FOLLOWING INSTRUCTIONS FOR FIXING OF THE DRIVE UNIT ASSEMBLY TO THE DOOR ARE FOR A
RIGHT HAND INSTALLATION.
(Refer to Fig 2-7).
a) Check the door U-bolt is securely tightened on the LEFT hand side of the door.
b) Raise the door and tie a rope around the centre to secure the roll.
c) Support the right hand end of the door with a suitable prop, e.g. step ladder and soft padding to protect the
door surface
(Fig. 2)
STOP WARNING:
DO NOT ALLOW CHILDREN/PEOPLE AROUND THE DOOR WHEN PROPPED. SERIOUS PERSONAL
INJURY AND/OR PROPERTY DAMAGE CAN RESULT FROM FAILURE TO FOLLOW THIS WARNING.
Fig: 2
