ROLL.in.One Installation Instructions & O
wner’s
Manual
Page 6
l)
Locate the weight bar on the centre of the bottom rail and drill two locating holes through the holes on the weight bar
into the bottom rail. Secure the weight bar with two bolts provided.
(Fig 6)
Security Screw:
Fully close the door, mark the corrugation just before the curtain leaves the top roll, drill through the curtain
and the drum wheel rim and apply a ‘pop rivet’ or self-tapping screw. This must be done at both ends of the door (Fig. 7)
NOTE: After marking the flute the curtain may be raised to give access to drilling etc.
WARNING: Care must be exercised when drilling to avoid internal wiring.
IMPORTANT:
Security rivet / tek screw must always be applied to inner side of drum wheel as shown in
Fig: 7a
. Failure to do
so may result in internal damage to the Roll.in.One drive unit.
Fig: 6
Fig: 7
Fig: 7a
