PART TWO - INSTALLATION
SECTION 1 - UNPACKING
Rev. 2-300
Accu4™ Low-range Turbidimeter System
19
P A R T T W O - I N S T A L L A T I O N
S
ECTION
1
After unpacking, it is recommended to save the shipping
carton and packing materials in case the instrument must be
stored or re-shipped. Inspect the equipment and packing
materials for signs of shipping damage. If there is any evi-
dence of damage, notify the transit carrier immediately.
S
ECTION
2
2.1 Sensor Location
Locate the Model 8320 turbidity sensor indoors or outdoors
within 30 ft. (9 m) of where the Model T53 analyzer is to be
installed. The sensor may be installed in an “in line” process
configuration using a closed loop piping arrangement (Fig-
ure 2-1) or in a sample bypass line configuration using an
open drain piping arrangement (Figure 2-2).
FIGURE 2-1 Recommended Closed-loop Sensor Piping Arrangement
UNPACKING
MECHANICAL REQUIREMENTS
