40
Glentek Inc., 208 Standard Street, El Segundo, California 90245, U.S.A. (310) 322-3026
CHAPTER 6: START UP AND CALIBRATION
Pot/Dip Switches
AMP1
AMP2
AMP3
AMP4
TACH J3-C to J3-F (
+
)
SIG. 1 J3-A to J3-F (
+
)
SIG. 2 J3-B to J3-F (
+
)
COMP J3-D to J3-F (
+
)
CURRENT LIMIT J3-E to J3-F (
+
)
Signal input to Tach ratio:
_V Signal / _V Tach
LIMIT(PULL UP/DN)
S1-8(8105), S2-8(8205)
INHIBIT(PULL UP/DN)
S1-7(8105), S2-7(8205), S1-5(8305)
RESET(PULL UP/DN)
S1-3(8105), S2-3(8205), S1-4(8305)
LIMIT(ACTIVE HI/LOW)
S1-5(8105), S2-5(8205)
INHIBIT(ACTIVE HI/LOW)
S1-4(8105), S2-4(8205), S1-3(8305)
RESET(ACTIVE HI/LOW)
S1-3(8105), S2-3(8205), S1-2(8305)
MTR TEMP(ACTIVE HI/LOW)
S1-2(8105), S2-2(8205), S1-1(8305)
+15/+5
S1-1(8105), S2-1(8205), S1-6(8305)
6.6 Calibration Setup Record:
It is good practice to keep a record of all pot settings. Doing so will facilitate calibration
on future units and repair on this unit. Although not a substitute for the calibration procedure,
it will at least get you "in the ballpark." Remove the power and allow all capacitors to
discharge before taking measurements. Note: The balance pot should not be measured in
this fashion, set per step 4 in the calibration procedure.
Date data taken:
/
/
Serial number S/N:______________
Model number SMA_____________________________________
