Glenmac Harley T6, Operator'S Manual

Page: 18 / 40

16 PN-P970612 (06/2005)
Shutting Down
Stop equipment.
Lower the lift arms and power rake to the ground.
Purge any air in the system. Hydraulic system leak-
down, hydraulic system failures, mechanical failures,
or movement of control levers can cause equipment to
drop or rotate unexpectedly.
Shut off engine, set brake, remove key, and remove
seat belt before leaving the tractor operator’s seat.
WARNING
•
Do not disconnect hydraulic lines until all
system pressure is relieved. Lower unit to
ground, stop engine, and operate all hydraulic
control levers.
REMOVING POWER RAKE FROM TRACTOR
WARNING
•
Do not allow other people in the area when
operating, attaching, removing, assembling,
or servicing equipment.
Install endplates on attachment side of power rake as
shown in Figure 2 (page 17).
Lower jackstand to “storage” position.
On a hard level surface, lower attachment to the ground.
Shut off engine, set brake, remove key, and remove seat
belt before leaving the tractor operator’s seat.
WARNING
•
Do not disconnect hydraulic lines until all system
pressure is relieved. Lower unit to ground, stop
engine, and operate all hydraulic control levers.
Disconnect driveline from tractor PTO shaft and support
with storage chain.
Disconnect 3-point upper and lower links from power
rake.
Disconnect hydraulic hoses from quick couplers.
Install dust plugs for storage.
Move to tractor seat and start engine. Release brake
and drive tractor forward until it is disengaged from
the attachment. The attachment should rest in a stable
position for storage.
STORAGE
Make sure the disconnected power rake is stored on a
hard, level surface. Endplates mounted on attachment
side of rake increase stability.
CAUTION
•
Keep children and bystanders away from
storage area.
OPERATION
NOTES