Glenmac Harley T6, Operator'S Manual

Page: 14 / 40

12 PN-P970612 (06/2005)
Safety is a primary concern in the design and
manufacture of our products. Unfortunately, our efforts
to provide safe equipment can be wiped out by a single
careless act of an operator.
In addition to the design and configuration of equipment,
hazard control and accident prevention are dependent
upon the awareness, concern, prudence, and proper
training of personnel involved in the operation, transport,
maintenance, and storage of equipment.
It has been said, “The best safety device is an informed,
careful operator.” We ask you to be that kind of an
operator.
The operator is responsible for the safe operation of
this equipment. Operators must be instructed in and
be capable of the safe operation of the equipment, its
attachments, and all controls. Do not allow anyone to
operate this equipment without proper instructions.
The power rake is designed for removing rock, and
small debris, and for thatching. This manual contains
information for the T6 model. Refer to the information
in this manual for specifications, parts, assembly, and
adjustment.
WARNING
•
Safety instructions are important! Read all
attachment and power unit manuals; follow all
safety rules and safety decal information.
(Replacement manuals are available from
dealer or, in the United States and Canada, call
1-800-437-9779.) Failure to follow instructions
or safety rules can result in serious injury or
death.
•
Do not allow children or untrained persons to
operate equipment.
•
Power unit must be equipped with ROPS or
ROPS CAB and seat belt. Keep seat belt
securely fastened. Falling off power unit can
result in death from being run over or crushed.
Keep foldable ROPS systems in “locked up”
position at all times.
•
Do not allow other people in the area when
operating, attaching, removing, assembling, or
servicing equipment.
•
Never go underneath equipment lowered to the
ground or raised. Never place any part of the
body underneath equipment or between
moveable parts even when the engine has been
turned off. Hydraulic system leak-down,
hydraulic system failures, mechanical failures,
or movement of control levers can cause
equipment to drop or rotate unexpectedly and
cause severe injury or death.
•
Service work does not require going
underneath equipment.
•
Read Operator’s Manual for service
instructions or have done by a qualified
dealer.
•
Before dismounting tractor or performing any
service or maintenance, disengage power to
implement, lower the 3-point hitch and all
raised components to the ground, operate valve
levers to release any hydraulic pressure, stop
engine, set parking brake, remove key, and
unfasten seat belt.
•
Ensure implement is properly attached,
adjusted, and in good operating condition.
ATTACHING POWER RAKE TO TRACTOR
Move tractor into position in front of the power rake.
Move back slowly and carefully, not allowing anyone
to be between the tractor and the rake. Turn off tractor
engine. Attach the two lower arms of the 3-point hitch
with the two hitch-pin assemblies.
Attach the tractor center link to the upper hitch point
of the power rake. Use either the “lock-out” setting or
the “float” feature depending on your application.
Attach the front PTO from the power rake to the tractor.
Slide the front section of the PTO into the back section
and attach to the PTO shaft at the rear of the tractor.
Wrap driveline storage chain around hitch tube and
secure it so that it will not contact PTO driveline.
OPERATION