GLASCRAFT GUARDIAN A6-6000, User Manual

Page: 15 / 48

13
Section 1 - Installation: Equipment Assembly
If the wire is short of the ferrule end, adjust the strip
length accordingly. If bare is protruding from the
ferrule, trim it flush to the end of the ferrule.
21.
Remove the ferrule and apply oxide inhibitor to the
bare wire.
22.
Reinsert the wire in the ferrule and apply more
oxide inhibitor to the ferrule and wire end.
23.
Pair the electrical wires as follows:
A-Hose to A-Hose
B-Hose to B-Hose
When connecting the first hose to the proportioner,
wire painting does not make a difference.
24.
Insert one wire from the heated hose into the
connector. Ensure that the ferrule is mating with
the connector insert and attach the set screw.
Torque the set screw to 60 in.-lbs. (6.78 N•m).
To reach approximately 60 in.-lbs. (6.78 N•m),
complete 4.5 revolutions with the hex wrench
after the set screw contacts the ferrule.
25.
Repeat steps 21 through 24 for remaining.
Re-torque all four set screws to 60 in.-lbs. (6.78 N•m),
The set screws will be approxitmately flush with the
connector.
2.
Insert the cap plugs over the set screws.
2.
Repeat steps 21 through 26 for additional hoses.