GLASCRAFT GUARDIAN A6-6000, User Manual

Page: 14 / 48

12
Section 1 - Installation: Equipment Assembly
15.
If the optional scuff-jacket p/n FM-494 is being
used (highly recommended, sold separately)
install it over each individual section of hose
before proceeding any further. Securely tape both
ends of scuff jacket to the hose assembly.
1.
Locate the thermal couple wire protruding from the
B side fitting on the front of the machine. Un-coil
the wire and lay it out straight.
Main power from power source should be disconnected
or turned off to console before making hose
connections.
1.
Feed the the thermal couple wire into the B side
portion of the hose and pull the rest of the hose up
until you can connect the hose to the front of the
machine. Tighten the hose securely, being careful
not to twist the hose in an “un-natural” bend.
Refer to the last page in this installation guide for
instructions on how to secure hoses properly.
1.
Connect the 1/4 in. air line on the hose assembly to
the air line whip hose one the front of the machine.
1.
Connect the electrical wires.
• Ensure the wire ends are 5/8 in. (.625 mm) long.
If they are not, use a sharp pair of scissors to strip
all four wire ends to the correct length.
Be careful, do not cut or nick any copper strands. If
more than five strands are cut or nicked, trim and
re-strip the wires.
New hoses are pre-stripped to the correct length;
remove the insulation to expose the bare wire.
20.
Ensure the strip length is correct by fitting the ferrule
over the exposed wire. The ferrule should be flush
with the end of the wire.