C. INSTALLING THE NEW FABRIC
IMPORTANT: REPLACEMENT FABRICS ARE
ROLLED AND FOLDED
FOR
SHIPMENT. THE SEAMS MUST FACE DOWNWARDS AS THE FABRIC IS
INSTALLED. THERE IS A SMALL WHITE POLY (POLYESTER) ROPE INSERTED
IN THE FABRIC THAT WILL SLIDE INTO THE
LEAD RAIL
.
1.
2.
3.
manual.
The old fabric's trim insert will need to be removed from the
roller tube, it is
held on by clear tape along the length of the tube and black
duct tape on each
end. Take note of how the trim insert sits in the channel of
the tube as the new
fabric trim insert will need to be inserted correctly and
then taped in the same
fashion as the existing insert was attached.
With the new fabric attached to the tube, roll up the fabric as
even and tight as you can in
the correct direction. (The fabric should roll from the bottom
of the tube when the awning
is extending) Slide the tube with the motor and fabric assembly
back into the case of the
awning as it came out. Confirm the non motor side of the roller tube is correctly in the
bushing that is mounted on the non motor side endplate.
Repeat steps 1-10 of motor installation section B.
Page
44
of
49
Summary of Contents for GG750
