Page
15
of
49
C.
MOUNTING THE AWNING.
1. Lift the awning into position for fastening to the vehicle mounted brackets.
a. Ladders are usually sufficient; however, a scaffold or forklift may be used.
b. If using a forklift use all necessary caution to protect the surface of the
awning. Lift from the center of the awning to maintain product balance
while elevating.
2. Place the awning onto the brackets while feeding the motor power cable through
the hole. A small amount of lubricant may aid the feeding of the cable. Make
sure the grooves of the awning are securely engaged into the channels on the
bracket. (Figure 4)
(Figure 4)
3. Secure the awning by moving the slide locks along the bottom awning track until
they are located
under their respective brackets (Figure 5). The final position of the
slide lock should be directly under the shoulder of the arm.
Summary of Contents for GG750
