Girard Systems GG750, Service And Repair Manual

Page: 9 / 49

Page 9 of
49
Tools required:
• Electric Drill
GETTING STARTED
• Tape measure
• (2) ladders
• Chalk line
• Flat head screwdriver (small)
• Phillips screwdriver
• Caulking gun
• (2) tubes silicone caulking
• Drill bits: 1/8”, 3/8”, 7/16”, 1/4”
• Allen wrenches: 4mm
• Open-end wrenches: 19mm, 17mm
• Keyhole saw
A. UNPACKING
1. Before starting any of the installation procedures unpack the awning and
inspect the product for any possible damage that may have occurred during
shipping.
2. Before starting any of the installation procedures ensure that the length,
fabric, and
motor placement of your awning are correct.
3. When you have determined that the product is to your satisfaction, remove
the mounting brackets and place the awning in a safe location while
preparing the RV.
a. To remove the brackets locate the slide lock that retains the bracket to
the housing. (Figure 1)
b. Using a 4mm Allen wrench, loosen the set screws on the slide locks.
c. Once the set screws have been loosened the slide locks should slide
freely, clear the slide lock away from the bracket.
d. You should now be able to remove the bracket.
4. If you have discovered any damage or missing parts please contact your
supplier.