Page
16
of
49
(Figure 5)
4. Once the final location of the slide locks has been achieved, tighten both set screws
on each slide lock with a 4mm Allen wrench (Figure 6). This secures the awning in
place.
(Figure 6)
(OPTIONAL, WEATHER STRIPPING NOT INCLUDED, SIDEWALL
APPLICATION ONLY)
1. Trim weather stripping to the length of the awning and remove any overhang.
2. Make a small cut in the weather stripping to allow for the motor cord.
3. Apply generous beads of silicone along the weather stripping.
4. Push weather stripping firmly into place.
5. Wipe off excess silicone.
Summary of Contents for GG750
