23
Assigning door opener
The door opener connected to the control device is assigned
to the "main" door station. It is activated if the
button at a
home station is pressed spontaneously, even without any pre-
vious conversation.
The door opener of a "back/side" door is connected to the
switching actuator. It can be activated via the
button if a
door call was previously initiated from the door station of a
"back/side" door. It is switched to the "main" door 2 minutes
after the door call or 30 seconds after the door call.
Assigning door opener of "main" door
The door opener connected to the control device is pro-
grammed at the respective door station as follows:
1. Press the "Systemprog." button on the
control device
for
3 seconds to start programming mode (see Page 19).
2. Press the "Türöffnerprogr." button on the
control device
for 3 seconds to start the door-opener programming
mode.
✓
The LED next to the "Türöffnerprogr." button flashes.
3. Press any call button on the
door station
for 3 seconds
until you hear a short acknowledgement tone.
✓
A long acknowledgement tone confirms successful
assignment. In addition, the door opener connected to the
control device is operated for the set time.
To assign additional door stations to the door opener (maxi-
mum of 3), repeat Step 3 on the next door station.
4. Press the "Türöffnerprogr." button on the
control device
to
exit door opener programming mode.
5. Press the "Systemprog." button on the
control device
to
exit the programming mode.
