8
1.2 Positioning
Remove the unit from the packaging and make sure it is in perfect
condition�
Before installing the appliance, remove the two screws
blocking the heating element from the back (
Fig. 1
)
Place the unit where it is going to be used, keeping it away
from walls, flammable cladding materials or other flammable
parts� Position the
salamander under an exhaust hood to guarantee complete
aspiration of the steam produced when cooking� Do not
install the appliance above hot surfaces�
Level and adjust the height of the unit
by means of the levelling feet�
Take the protective film off the outer
panels, pulling it away slowly so no
traces of glue are left�
Do not obstruct the aspiration or
heat vents
�
If you put the unit on a table, leave at
least 50 mm between the back of the
unit and the rear wall (
Fig. 2
)�
To wall mount the salamander use the
wall-mounting brackets and screws and
inserts suitable for the type of wall and
unit weight�
1.3 Electric connection
Before connecting the unit to the mains check that both the voltage
and frequency on the rating plate are the same as those of the electrical
supply system you are using�
The unit is delivered ready for use indicated on the rating plate located
on the side of the appliance�
To connect the unit to the mains, thread the cable type H07RN-F (cut
down to the right length) through the hole on the back of the appliance
and connect to the junction box on the right side following the guidelines
Fig. 1
Fig. 2