16
4.3 User interface
It’s refers to
fig.8
�
On/off button; when the appliance is switched off all the
functions are switched off as well�
This button allows you to start or stop cooking and hold
modes;
This button allows you to select either cooking or hold modes
in case of manual cooking; in case of program selection you
can pass from cooking mode to hold mode and viceversa;
These buttons increase or decrease cooking time and/or heat
intensity of the hold mode
This button allows you to set the cooking session with all
resistances or just the central resistances;
These buttons cannot be used when the appliance is in START
mode; thus the following instructions only refer to ON or
STOP mode; you can select a program by briefly pressing the
corresponding button� You can enter the program selection
mode by holding down the button; you can then save current
settings and go back to normal functioning by briefly pressing
the same button again;
MANUAL MODE
Switch on the salamander by pressing the ON/OFF button
Press the MODE SELECT button to select the type of mode (cooking or
hold – the corresponding LED above the display will come on)
Set time and intensity and then press START or place the plate on the
plate detection device to start the session (cooking mode will terminate
once the time set ends and a buzzer will sound); pressing the START/
STOP button or removing the plate (the plate detection device switches
appliance off) will cause the HOLD mode to switch off�
AUTOMATIC MODE
Switch on the salamander by pressing the ON/OFF button
Select the desired program by pressing the P1 or P2 or P3 button
Press START or place the plate on the plate detection device as in the
manual mode�