GIMA SpA
IONO BASE PLUS
44 Manuale
d’Istruzione/Instruction’s
Manual
MA342IGBa
HYPERHYDROSIS
The therapy is made graduating a low intensity current generator connected to two
water containers (for the hands and feet’s hyperhydrosis), can be used some suitable
sizes containers, it is better in insulation material (plastic container for foods). If you
use conductive material container (aluminium), the two containers must not be in
contact and keep attention to not touch, with wrist or ankle, the container, during the
treatment.
Connect to the output cables the electrodes covering them with the sponge-envelope
(see fig.8 or chapter “Installation and treatment start”).
Dip the two electrodes recovered by the sponge-envelopes, positive and negative of the
same channel in two different containers, one for the positive and another one for the
negative one. Add water so that when the hands or feet are dipped, the level do not
higher than the which one shown in the figures C e D of the next paragraph. The output
level must be so that the patient feels a little current passage without any troubles.
In the hands treatment it needs to be assisted by a trained person that controls the unit
during the treatment.
Before start the treatment, it is recommended to check that the position is comfortable
so that you do not move the limbs. If it is necessary, before move again the hands or
feet from the containers, interrupt the treatment on the unit (key stop to stop the
output’s current). At least ten sessions are necessary (20 minutes for every one). After
the first four-five sessions there is an improvement that proceeds by the successive
sessions until to the normal-hydrosis. The cure usually allows a garrison of a duration
between 30 and 60 days. Then it needs to subject to a keeping therapy with short cycles
of sessions.