14
3. Press button ‘M1’ or ‘M2’ again to subtract or add the number, and press button
‘START’ for confirmation;
4. When the hour number setup is finished, the minute number will flash automatically. Please follow the
same instruction as above to set minute number;
5. Press button ‘START’ for confirmation.
6. When the device stands by, press button ‘F’ three and four times respectively to enter into alarm 02
and 03 mode. Repeat the above process if you need a second and third alarm clock.
Annotation: When the alarm is on under device stands by, the icon ‘ ’ flashes on LCD and goes with
beep for 1 minute. Press the button ‘START’ to turn off the alarm.
When the alarm is on during measurement, the icon ‘ ’ flashes on LCD for 1 minute without beep.
Under this situation, if you press the button ‘START’, it will stop both the icon ‘ ’ flashing and meas-
urement.
Reminders clearance
1. When the device stands by, press button ‘F’ two times to enter into alarm 01 mode, then press button
‘M1’ for at least 5 seconds, the display will show as Fig.7 which means the alarm 01 is removed.
2. When the device stands by, press button ‘F’ three and four times respectively to enter into alarm 02
and 03 mode . Repeat the above process to remove the alarm 02 and alarm 03.
AMBIENT TEMPERATURE DISPLAY AND ADJUSTMENT
This monitor can display the ambient temperature and the unit °C and °F can be adjustable. °C mode
display in the LCD when the first time used.
1. When the device stands by, press button ‘F’ five times to enter into the temperature adjustable mode,
then press button ‘M1’ to turn into °F mode and press button ‘START’ for confirmation.
2. Press button ‘M2’ to convert °F mode into °C mode.
Annotation: When under the mode of function reset, if without any operation in 1 minute, the device will
automatically return to standby mode.
CARRY OUT A MEASUREMENT
1. Insert the tube plug into the air connector. Before the measurement, take 3~5 times deep breath and
relax yourself. Don’t talk or move your arm;
2. Press button ‘START’, and all symbols will appear on display in 2 seconds as Fig.9. Then two short
beep will sound and ‘0’ will appear on the screen. Pump begins to inflate with display showing the
reading of pressure. Generally the pressure will reach 190mmHg as Fig.10;
ENGLISH