GILES GVH-C, Operation & Service Manual

Page: 35 / 68

25
Model: GVH-C & GVH-F Overview
3.01 Control Panel
Item Description Function
1
Power Switch
(Push-To-Start)
The Power Switch is a 3-position Switch. Press and momentarily
hold the top [START] portion of the switch to start hood and
provide power to the appliance underneath. When released, switch
remains in the [ON] (centered) position. To turn hood OFF press
the bottom of switch (power to appliance is also turned OFF ).
2 HOOD POWERED Light
Light is ON when the Power Switch is in the [ON] position. The
Filter Access Door must be properly closed before hood will power-
up.
3 APPLIANCE POWERED Light Light is
ON to signal that the appliance underneath the hood is
receiving power and ready for use.
4
E.A.C. Filter Status
Indicators
LED light cluster indicates the status of the Electronic Air Cleaner
(E.A.C.).
[ON] - Turns ON when hood is powered-up. Indicates that the
E.A.C. system is powered and functioning normally to clean the air.
This is the only light ON when E.A.C. is operating properly.
[WASH] - Indicates excessive grease film build-up on collector fins
(dirty), collector cell is missing, poor contact, missing ionizer wires,
etc. Approximately 2 minutes after this light turn ON , a
intermittent (beeping) alarm tone will begin sounding and power to
appliances is shutdown.
IMPORTANT! Do not rely on this indicator as a signal for routine
cleaning; cell must be cleaned daily to maintain peak performance
and extend the useful life of charcoal filters.
[CHECK] - Indicates that collector cell has stopped operating
properly; either damaged & shorted to ground, fins shorted due to
excessive moisture, etc. No alarm sounds & the appliances remain
powered, but air cleaning system is not functioning.
5
CHARCOAL OR BAFFLE FILTER
CLOGGED Light
Light will turn ON if either the Baffle Filter or Charcoal Filter is
dirty/clogged, or other airflow obstruction is present.
6
CHARCOAL OR BAFFLE FILTER
MISSING Light
Light will ON if either the Charcoal or Baffle Filter is missing or
installed improperly.
7
EAC Cleaning Timer
[CHANGE SOON] Indicator
Turns ON when timer enters [WARNING MODE] , indicating that the
EAC Cell must be cleaned within the next 24 hours .
8
EAC Cleaning Timer
[CHANGE NOW]
Indicator
Turns ON when timer enters [TIMEOUT MODE] , indicating that the
maximum time between cleanings has expired. Cell must be
cleaned immediately. Power to appliance underneath hood is
turned OFF until cleaning is performed. Timer resets automatically.
9
EAC Cleaning Timer
[SNOOZE]
Button
Pressing button, after [TIMEOUT] is active, returns Timer to
[WARNING MODE] and allows use of appliance for two (2)
additional hours . Two (2) [SNOOZE] periods can be used.
Afterward, power to appliance is locked-out until EAC Cell/Hood
cleaning is performed.