Gigamon GigaVUE H Series, Hardware Installation Manual

Page: 33 / 55

■
Switch to the Configure mode. Refer to Enter the Configure Command-Line Mode .
■
Configure SSH access to the node. Refer to SSH2 .
■
Configure some basic user accounts. Refer to Initial User Account Configuration .
■
Configure the node name. Refer to Configuring the GigaVUE TA Series TA Series
Host Name .
■
Configure time and date options for the node. Refer to Configuring GigaVUE TA
Series TA Series Node’s Time Options .
■
Enable the Web server for Web-based GUI access. Refer to Enabling the Web Server .
■
Save your changes! Refer to Saving Changes .
Enter the Configure Command-Line Mode
Keep in mind that the GigaVUE-OS have three different command modes for the CLI –
Standard , Enable , and Configure . The commands described in the sections below are all
only available in Configure mode. Switch to configure mode as follows:
Command Notes
> enable You only need to supply enough of each
command to positively identify it among the other
available commands. So, in this example, you
could just type
ena and press Enter.
# configure terminal Similarly, this command can be entered as con t .
(config) # Notice how the system prompt changes with each
command mode. Command modes offer greater
control over the box as you ascend from
Standard
to Enable to Configure .
SSH2
SSH2 is available for remote connections to the GigaVUE TA Series Traffic Aggregator’s
Mgmt port. By default, SSH2 is enabled. Use the ssh commands in Configure mode to
enable or disable the corresponding connections. To disable the corresponding
connection, you include
no before the command, as demonstrated in the table below.
For example:
Contents
33
GigaVUE-TA25E Hardware Installation Guide