GiBiDi BARR500, Instructions For Installation Manual

Page: 25 / 56

25 BARR500
UK
BOOM LIGHTS (38)
Two light tubes can be fitted on the standard boom profile to enhance boom visibility.
Figure
38 shows the correct way to install the light tube. The power cable (1) runs through the hollow section of the
boom where it is connected to the light tube (3) which in its turn is housed in the seats cut into the profile until
terminating at the same side as the power cable (2) .
It is recommended to use joints and terminals specifically for the light tube used.
SENSITIVE EDGE
The standard profile allows fitting a sensitive edge type 8K2 without requiring further supports.
FLASHLIGHT (39)
Signalling system integrated in the boom cabinet.
UNLOCKING WITH EUROPEAN KEY (40)
Allows accessing the unlocking system using a key with European cylinder.
BOOM COUPLING COVERS AND BOOM END COVERS (41)
These are particularly useful to arrange the boom accessory wiring (lights and sensitive edge) and an attractive
finish.
Maintenance must be performed by the installer and/or by qualified persons.
Every 6 months or 100,000 manoeuvres it is advisable the inspect the system:
•
Visually inspect the operator and clean it if necessary.
Check that the boom is properly aligned.
Check proper functioning of the electrical limit switches and mechanical end-stops.
Check the efficiency of the release system.
Check that the spring/s are properly adjusted.
Lubricate the spring/s with adhesive grease spray.
Check that the boom coupling is securely fastened on the splined output shaft.
Check the state of wear of the self-lubricating plastic bushing of the balancing device.
Check the condition of the drive Cable and lubricate it.
Check that the gearmotor is secured to the cabinet.
Check the integrity of the connection cables.
Check the efficiency of the batteries (if present).
•
•
•
•
•
•
•
•
•
•
•
MAINTENANCE
In the event of any malfunction, cut the power to the system and call in a qualified technician (installer).
MALFUNCTIONING