Giant MY20, Service Manual

Page: 21 / 106

21
LOW SPEED MODE
In some markets, assistance will stop at a lower speed (20 Km/h - 15 mph)
due to local requirements. This “Low Speed Mode” is a setting in the motor
and can be activated and deactivated by using a certain button sequence on
the Ride Control. Older hardware & firmware versions have a very simple
sequence (Method 1), later versions have a slightly modified sequence
(Method 2), to prevent activating low speed mode by accident. MY20 bikes all
have firmware with method 2, modified button sequence
LOW SPEED MODE - METHOD 1 (OLD VERSION)
1 Turn on the bike.
(Speed must be 0)
2 Push light button 5 times, within 6 seconds.
3 Turn the bike off to save the change.
LOW SPEED MODE - METHOD 2 (NEW VERSION)
1 Turn on the bike.
(Speed must be 0)
2 Push assist down button until assist level is set to “Off”
3 Push and hold walk assist button.
4 Push light button 5 times, within 6 seconds.
5 Release walk assist button.
6 Turn the bike off to save the change.
Assist Down
Walk Assist
Light/Mode button
On (short press)
Off (long press)