Giant MY20, Service Manual

Page: 58 / 106

58
2
Stick the finger-notch rubber onto the inside of the cover. Make sure the
edges line up neatly with the cover.
3
Now place the bottom side rubber against its slider
4
Slide the battery towards the fixing screw’s mounting bracket of the
cover. Make sure the fixing screw’s mounting bracket sits tight against
the face of the battery.
5
The ridges on both sides of the inside of the cover should go into the
grooves in both sides of the battery. Slide in one side first, snap the other
side in by hand. Push the ridges of the bottom side of the cover into the
grooves in the battery. It should require some force, but not too much, to
firmly snap them in place.
6
Secure the cover with the screw. Do not overtighten, just hand-tight is ok
7
Peel off a small part of the paper film of the side rubber. Start with the
flattened, “pointy” side of the rubber as shown.