44
Photo cell ignore function
Parameter "3.2":
Function
Photo cell function disabled
"0"
Off
"1"
On
Set parameter “3.2” = 1 and then exit programming to activate the “photo cell ignore” teach-in
mode.
Warning!
•
Presence detection “stop and re-open” is disabled in the Teach-in mode
In the Teach-in mode, the door must be fully opened and closed twice. The photo cell must
be interrupted twice at the same door position. The Teach-in mode then terminates. The
photo cell does not function below this stored door position.
Teach-in mode display
Upon exiting the programming
When the light beam is interrupted for the first time (1
st
open / close cycle)
After the second interruption of the light beam, 2
nd
open / close cycle and must be
at the same door position as the interruption in the 1
st
cycle, at the final limit
CLOSE position
Note!
•
If the teaching-in is not successful, open and close the door again until the photo
cell has been interrupted at the same door position twice.
