+GF+ SG 160, Instruction Manual

Page: 10 / 60

2 General Operating instructions SG 160
6
2 General
2.1 Introduction
This instruction manual was written for those persons responsible for the
operation and care of the SG 160. It is expected and assumed that such
persons have read, understood and will abide by the manual in its entirety.
Only with the knowledge contained in this manual can faults on the SG 160 be
prevented and trouble-free operation be ensured. It is therefore imperative that
the responsible persons are familiar with this manual.
We recommend that this manual be read carefully prior to putting the machine
in operation, as we are not liable for any damage or interruptions in operation
resulting from failure to comply with this manual.
Should problems nevertheless arise, please contact the nearest Georg Fischer
representative (see back of this manual).
This manual applies only to the SG 160.
We reserve the right to make the technical changes necessary to improve the
SG 160 which may result in deviations from the illustrations and information
contained in this manual.
2.2 Range of application
The SG 160 is designed exclusively for the fusion of plastic pipes, fittings and
valves in the dimension range d 32–160 mm (Butt fusion) and d 16–110 mm
(Socket fusion). Any other use is not authorized. The manufacturer cannot be
held liable for damages resulting from unauthorized use; the user bears sole
responsibility.