TSA 160 NT and variants
25
Installation
X
Fasten the bearing block (2) on the door leaf
with 2 screws M6.
X
Adjust the connecting link arm (7) to length,
pre-tension the lever arm manually. The
connecting link arm (7) must be positioned
perpendicularly (9
0°) to the door level and
the lever arm must be
pretensioned by approx. 15°.
X
Tighten the 2 screws (6).
6.3.2 Install the drive on the hinge side (pulling; roller guide rail) TSA 160 NT / TSA 160 NT Z Invers
X
Press the spacer bush (2) into the lever bush.
X
Slide the roller lever (4) onto the drive shaft (1) at
an angle of 15° to the door level and fasten with
the screw M6 (3).
X
Screw valves SG (5) and SD (6) in completely.
Note the number of turns required.
X
Turn the roller lever (4) back slightly in the oppo-
site direction.
The roller lever stops in this position.
X
Install the roller guide (7) on the door leaf with 2
screws M5.
X
Close door
X
Screw the drive onto the lintel or prepared
mounting plate.
X
Return SG (5) and SD (6) valves to their original
setting.
X
Lightly push roller lever (4) upwards and allow it
to latch into the guide rollers (7).
