Getac W130 Series, Operator'S Manual

Page: 126 / 134

PC Card Problems
The PC Card does not work.
z
Make sure that the PC Card is correctly seated.
z
If the card requires an IRQ (interrupt request), make sure that there is
one available.
z
The PC Card may be attempting to use a COM port in a manner that
conflicts with the COM port being used by another device. Try running
the SCU program to change the COM port setting. If your PC Card uses
COM1, set COM1 as
Disabled . If your PC Card uses COM3, set COM3
as Disabled . If your PC Card uses COM4, set COM4 at Disabled .
WARNING: COM3 is reserved for use by the touchscreen, do not disable it. If COM1/2 is
disabled and COM3/4 is enabled on the SCU Setup (refer to chapter 5), upon
booting system would recognize the enabled COM3/4 and designate it as COM1/2.
The following table is the default settings:
COM Port I/O (input/output) Port IRQ (Interrupt Request)
COM1 (available) 3F8 IRQ4
COM4 (reserved for
Wireless Modem) 2E8 IRQ5
COM3 (reserved for
touchscreen only) 3E8 IRQ3
The PC Card stops communicating properly.
z
The application may have been reset when the computer is turned off
or in Standby mode. Exit and restart the application.
Power Management Problems (for Windows)
The computer does not enter Standby or Suspend mode
automatically.
z
If you have a connection to another computer, the computer does not
enter Standby or Suspend mode if the connection is actively in use.
Troubleshooting
8-11