GESTRA NRR 2-40, Installation Instructions Manual

Page: 38 / 40

38
LED bus status is flashing slowly
Fault:
The data transfer in the CAN bus is interrupted!
Remedy:
The wiring of the bus lines must be in accordance with the wiring diagram (observe polarity).
As specified in the wiring diagram provide the
endofline bus devices
with 120
Ω
terminating resistors.
Cut off power supply and restart system.
Fault: A malfunction in the CAN bus has occurred.
Remedy: Restart system.
Fault: The baud rate setting(s) of at least one bus device is not correct.
Remedy: Check the baud rate settings of all busbased devices.
The baud rates must be identical!
Cut off power supply and restart system after 5 sec.
Fault:
The total length of the bus line does not correspond to the baud rate setting!
Remedy:
Check the baud rate settings of all busbased devices.
Cut off power supply and restart system after 5 sec.
LED bus status is flashing slowly
MIN / MAX alarm.
System malfunction 3
System malfunctions
– continued –
LED is flashing slowly
LED is flashing slowly
1
2
3
4
Test
P
1 2 3
E
4
MAX
MIN
W
X
W
+
-
GESTRA
NRR 2-40
1
2
3
4
Test
P
1
2
3
E
4
MAX
MIN
W
X
W
+
-
GESTRA
NRR 2-40