P.11
P.10
This appliance must be correctly installed by a suitably qualified person, strictly in accordance with
the manufacturer’s instructions.
The manufacturer declines any responsibility for injury or damage, to person or property, as a result
of improper use or installation of this appliance.
•
Heat, steam and moisture will be created during use of the appliance, take care to avoid injury
and ensure that the room is adequately ventilated. If the appliance is going to be used for
prolonged periods of time, then additional ventilation may be required.
•
Please consult with your qualified installer if you are in any doubt about the amount of ventilation
that you will require.
•
Make sure all control parts are working properly during installation.
•
This built-in oven can be placed in high cabinets or walls. Paint or glue that used in such furniture
shall be heat-resisting to prevent surface distortion or coating separation.
•
Please install the oven according to the size given in the drawing below.
•
The four screws showed in the drawing below are not allowed to be removed after the oven is fully
inserted into the cabinet.
Installation Instructions
Installation Instructions
Exhaust vents
Air Inlet
555
50
≥
550
≥
560
35
≥
560
545
530
595
595
23
Product Dimensions
Aperture Dimensions
Height: 595 mm
≥ 550 mm
Width:
595 mm
≥ 560 mm
Depth:
530 mm
≥ 560 mm (min)
Positioning the appliance
•
Ensure that the aperture that you will be fitting the oven into is of the size given in the above
diagram.
•
The oven must be fitted into an oven housing with the ventilation cut-outs shown in the
“Ventilation Requirements” section on the next page.
•
Ensure that the rear panel of the furniture housing unit has been removed.
