Gericom SilverSeraph CL10, User Manual

Page: 12 / 150

12
c/ Automatic calls to different numbers shall be not less than
5 seconds apart.
• Immediately disconnect this equipment should it become
physically damaged, and arrange for its disposal or repair.
• The correct settings for use with this modem in New Zealand
are as follows:
ATB0 (CCITT operation)
AT&G2 (1800 Hz guard tone)
AT&P1 (Decadic dialing make-break ratio =33%/67%
ATS0=0 (not auto answer)
ATS10=less than 150 (loss of carrier to hangup delay, factory
default of 15recommended)
ATS11=90 (DTMF dialing on/off duration=90 ms)
ATX2 (Dial tone detect, but not (U.S.A.) call progress detect)
• When used in the Auto Answer mode, the S0 register must be
set with a value of 3 or 4. This ensures:
(a) a person calling your modem will hear a short burst of
ringing before the modem answers. This confirms that
the call has been successfully switched through the network.
(b) caller identification information (which occurs between
the first and second ring cadences) is not destroyed.
• The preferred method of dialing is to use DTMF tones (ATDT...)
as this is faster and more reliable than pulse (decadic) dialing. If
for some reason you must use decadic dialing, your
communications program must be set up to record numbers using
the following translation table as this modem does not implement
the New Zealand “Reverse Dialing” standard.