42
CHAPTER 6
Modifying MAXX 2 Print Settings
print and make note of the setting that provides the best overlap. You will change the
Seam Adjust setting in the next procedure.
Note: As the MAXX 2 prints the Seam Adjust Sample will notice that the printer picks up and
drops off the process cyan cassette a number of times. These printer actions are normal and are
required to properly print the sample.
To change the Seam Adjust settings
1
On the control panel, press MENU >
Service
>
Calibration
>
Calibrate Print
. Scroll through
the list of vinyls until you find the proper vinyl, then press the corresponding function
key. The display is:
vinyl (such as 225)
< Seam Adjust
< Darkness Adjust
2
Press the
< Seam Adjust
function key. The display is:
< Print Seam Adjust Sample
< Change Seam Adjust
3
Press the
< Change Seam Adjust
function key. The display is:
Seam Adjust: 0
less [- - - - - X - - - - -] more
4
Change the Seam Adjust setting to the overlap setting chosen when examining the
Seam Adjust Sample. Press the UP key to increase the overlap or the DOWN key to
decrease the overlap, and then press ENTER.
5
Reprint your job and compare it to the original print. If the results are acceptable, you
are done. If the job requires additional adjustment you can alter the Seam Adjust
setting again. If the prints are still not acceptable call Gerber Field Service.
Summary of Contents for 2
Page 1: ...GERBER MAXX 2 Owner s Guide ...
Page 2: ......
