Introduction
1
Connecting to Power
You can connect to power using either the power adapter provided or a Power over Ethernet
er using the power adapter, follow the steps below to
res of the camera to the 3-pin or 2-pin terminal block
1.
Insert the yellow wire to the pin on the right-side of the terminal block and the orange
wire to the pin on the left-side of the terminal block.
2.
Use a small flat-tip screwdriver to secure the screws above the pins.
(PoE) adapter. To connect to pow
connect the orange and yellow wi
provided.
Figure 1-57
.
Connect the DC 12V Power Adapter to the Terminal Block.
3
DC 12V Power Adapter
Terminal Block
Figure 1-58
N
1
DC 12V power adapte
ided, but both AC 24V power adapter and DC
12V power adapter are compatible.
.
The power status LED will not be visible unless the camera cover is removed.
ote:
.
A
r has been prov
2
49