30
2.7 Setting UID or GID on GV-R/RK/DFR Config AP
By default, the readers read the UID (unique identifier) on ID cards or key fobs. Using GV-
R/RK/DFR Config AP, you can set the GV-RK1352 / R1352 / DFR1352 to read GID
(GeoVision ID) on GV-AS ID Cards / Key Fobs instead.
Note:
1. To see how to install the Config AP and how to identify the COM port of the reader,
refer to
2.4 Installing GV-R/RK/DFR Config A
P and
2.5.1 Defining the ID Number and
Setting the Reader to Slave
.
2. GID ID format is only supported in GV-RK1352 / GV-R1352 / GV-DFR1352 (Rev. B)
V1.2 or later.
3. If you are using third-party cards or key fobs, you must set the reader to read UID.
1. Run
GV-R/RK/DFR Config AP
.
2. Select the COM port that is connected to the reader and click
Open COM
. The red
square next to the COM port box should change to blue to indicate the COM port is
correct.
3. To set the reader to read GID, select
Only Read GID
.