S53-053 Panther
12 of 53
5
Remote control
With the crawler a remote control (Fig. 53 CW) is supplied. The controller works as a radio controlled control
(or can work with a cable attached). Driving the crawler is only possible by using the remote control.
Other functions, such as adjustment of engine RPM and levelling are installed on the control cabinet.
The remote control is equipped with an electronic output adjustment.
The adjustment applies to all levers.
To adjust: use the switch (Fig. 53 CW, item 4):
(push left to decrease output, push right once to increase to maximum)
Led not flashing:
0x/sec
Maximum
Led flashes:
1x/sec
Minimum
For further detailed information, refer to Scanreco manual.
If the remote control receiver loses contact with the remote control, the system will go
into an emergency stop.
