51
Result of both files processed together
Sensor Noise Test:
In order to do a sensor noise test you must compare the sensors parallel to one another. For
example if you have two receivers and Hy1 and Hy2 you can do a noise test for Hy1 and Hy2. It
is the same for Hx1 and Hx2 or for Ex1 and Ex4 (if you have three Ex channels on each receiver).
If you only have one receiver set the two coils parallel to one another and the electrodes
parallel. Since E channels 3, 4, 5, and 6 have shared terminals to test all E channels and the H
channels will require three acquisitions. As follows:
Set channels 1, 2, 3, and 5 as E-dipoles parallel to one another. This will provide
four E-field parallel measurements without any shared electrodes.
Do an MT acquisition.
Set channels 4 and 6 as parallel E-dipole channels.
Do an MT acquisition
Set Hx parallel to Hy.
Do an acquisition.
Start MTPro.
Go to FILE\PARALLEL TEST NOISE CALCULATION.
Add the GTS files from you parallel acquisitions
Open and view the files as is done when viewing standard survey data.
